Installing Flight Controller Battery
1. Adjust the throttle and throttle trim to the lowest settings.
2. Power on the FlySky aircraft transmitter.
3. Flip the quadcopter upside-down and install the battery by
connecting the battery connector to the flight control board
beneath the control unit.
4. Slide the battery into the bottom battery bracket ensuring
the battery is centered.
5. Place the RV Micro right-side up on a flat surface and
leave the aircraft still for approximately 5 seconds.
CAUTION:
Always disconnect the Li-Po battery from the aircraft when not flying to avoid over-
discharging the battery. Batteries discharged to a voltage lower than the lowest approved
voltage may become damaged, resulting in loss of performance and potential fire when
batteries are charged.
14
