Transmitter and Receiver Binding
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code
of a specific transmitter. You may need to ‘bind’ your FlySky aircraft transmitter to the receiver for proper
operation. If you purchased an RTF model, the transmitter is bound to the flight controller at the factory.
To bind or re-bind your RV Micro to your chosen aircraft transmitter, please follow the
directions below.
General Binding Procedure
1. Disconnect the flight battery from the quadcopter.
2. Set Throttle to idle and Center all sticks on your transmitter.
3. Power ON the FlySky aircraft transmitter and move all
switches to the up position.
4. To put the transmitter into bind mode, press the Setting Icon,
tap right to SYS and Select Rx BIND.
5. Connect the flight battery in the quadcopter while
simultaneously holding the bind button.
6. Before the battery has been connected, hold bind button.
7. After connecting the battery, release the bind button after 2–3
seconds. The bottom LED’s will flash slowly. Press the back arrow on the transmitter.
The quadcopter is bound when the LEDs on the flight control unit turn solid.
8. Disconnect the flight battery and power the transmitter off.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide
for other instructions. If needed, contact the appropriate M1 DRONES Product Support
office.
CAUTION:
When binding a flight control unit to the FlySky aircraft transmitter, you must have the throttle
at idle and make sure a second aircraft transmitter is not on the bind screen when attempting to
reestablish a bind.
15
