TC10EM
P. 40 / 43
EM-9581-B Rev.1
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
l
LOOP SETTING
(LED on for selected loop)
(n: Alarm number)
(x: Selected loop number)
LOOP1
LOOP2
LOOP
S.RUN
S.MODE
C.TYPE
C.LOGI
R.SP
SP.TRC
SP.L.LM
SP.H.LM
MV.STT
MV.STP
An.TYP
An.HYS
An.LAT
An.ON.D
An.OF.D
An. SP
An.OUT
MV.ERR
MV.L.LM
MV.H.LM
ERR.OP
CT.OP
ALM1
ALM2
ALM3
Loop x: Operation at startup
Loop x: Mode at startup
Loop x: Control type
Loop x: Direct/ reverse action
Loop x: Remote SP
Loop x: SP tracking
Loop x: SP low limit
Loop x: SP high limit
Loop x: MV at startup
Loop x: MV at stop
Loop x: MV at error
Loop x: MV low limit
Loop x: MV high limit
Loop x: Error action
Loop x: CT alarm action
Loop x: Alarm n: Type
Loop x: Alarm n: Hysteresis
Loop x: Alarm n: Latching
Loop x: Alarm n: ON delay
Loop x: Alarm n: OFF delay
Loop x: Alarm n: SP type
Loop x: Alarm n: Output
l
BANK SETTING
(LED on for selected loop, bank)
BANK1
BANK2
BANK3
BANK4
LOOP1
LOOP2
BANK
SP
SP.RA.D
SP.RA.U
PID1.P
PID1.I
PID1.D
PID2.P
PID2.I
PID2.D
A1.L.LM
A1.H.LM
A2.L.LM
A2.H.LM
A3.L.LM
A3.H.LM
H.HYS
C.HYS
D.BAND
M.RST
Loop x: Bank y: SP (setpoint value)
Loop x: Bank y: SP ramp fall rate
Loop x: Bank y: SP ramp rise rate
Loop x: Bank y: PID1 P (proportional band)
Loop x: Bank y: PID1 I (integral time)
Loop x: Bank y: PID1 D(derivative time)
Loop x: Bank y: PID2 P (proportional band)
Loop x: Bank y: PID2 I (integral time)
Loop x: Bank y: PID2 D(derivative time)
Loop x: Bank y: Alarm1 low setpoint
Loop x: Bank y: Alarm1 high setpoint
Loop x: Bank y: Alarm2 low setpoint
Loop x: Bank y: Alarm2 high setpoint
Loop x: Bank y: Alarm3 low setpoint
Loop x: Bank y: Alarm3 high setpoint
Loop x: Bank y: Heating sensitivity
Loop x: Bank y: Cooling sensitivity
Loop x: Bank y: Dead band
Loop x: Bank y: Manual reset
(x: Selected loop number)
(y: Selected bank number)