M-system MFTW120IX, Instructions And Advice For Installing, Using And Servicing

Page: 79 / 120

18
INSTRUCTIONS FOR THE USER
OVEN SIDE-GUIDE RAILS (fig. 9)
For an effective cleaning of the oven side-guide rails,
these can be extracted unscrewing knurled nuts (G).
To fit the rails back in their place, first insert rear pins
in holes and then secure them with the knurled nuts
(G)
OVEN DOOR REMOVAL
The oven door can be removed to give easier access
to the oven when cleaning.
To remove, proceed as follows:
• Open the oven door and insert rivet or nail (R) in
the hole (F) of the hinge (fig. 10).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards tilting
it slightly upwards to free sector.
• To reassemble proceed in the reverse order, paying
attention to the correct position of sectors.
REPLACING THE OVEN LAMP
Ensure the appliance is switched off before replacing
the lamp to avoid the possibility of electric shock..
In the event one or both oven lamps need replacing, the
new lamps must comply with the following requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be resistant to
high temperature (300°C).
The appliance can have two different types of lamp
holder:
• Lamp holder type 1 (fig. 11): Draw out the side guide
rails as described above.Then, remove the glass
protection cap (V) from the bulb socket, lifting it with
a screwdriver placed between the cap and the oven
wall and replace the lamp (L). Fit the accessories
back in reverse order.
• Lamp holder type 2 (fig. 12): Turn glass protection
cap (C) counterclockwise and change the lamp. Re-
fit the cap, screwing it back in a clockwise direction.
10
11
12
9
Downloaded from www.vandenborre.be