RCT 5023-G Reference Manual Rev 1.2
Page 15 of 57
LAN Connection
This is a standard RJ45 connection and is used to provide
TCP/IP network control connectivity into a control system.
Settings and Control
The RCT 5023-G is configured through the network
management utility in the APPolo Control SW
(see below in the GUI section of this manual).
Reset Button
There is a RESET button provided on the front edge of the
PCB.
Pressing this button for more than approx.. 5 seconds will
reset the RCT 5023-G to the factory configuration including
the IP address and ADMIN Password.
The controller will acknowledge the reset with a 3 x yellow
flashing of the LEDs.
