ISSUE DATE: FEBRUARY 2018
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: NOVEMBER 2015
APPROVED BY: S. GONZALEZ
PAGE 25 OF 38
PRODUCT INFORMATION MANUAL
SECTION: 12 LUMINETTE PRIVACY SHEERS
Connect PowerView
™
Components
Connect the Motor Assembly
■
Remove the orange cover from the drive assembly, as
shown to the right.
■
Align the pins with the holes in the drive assembly, as
shown below. Press the motor
up into the drive assembly until it clicks into place.
IMPORTANT:
If snapping the motor onto
the drive assembly seems difficult, grasp
the lead carrier and pull the carriers slightly
away from the motor, as shown at right.
The motor should now snap in easily.
■
If you remove the motor and need to reinstall it, check the drive assembly and make sure the tilt
gear aligns with the arrows.
➤
If necessary, use a screwdriver to turn the tilt gear until it is aligned.
Aligned Tilt Gear
