ISSUE DATE: FEBRUARY 2018
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: NOVEMBER 2015
APPROVED BY: S. GONZALEZ
PAGE 20 OF 38
PRODUCT INFORMATION MANUAL
SECTION: 12 LUMINETTE PRIVACY SHEERS
■
Mark where to drill holes for the installation screws.
➤
A minimum of 30mm flat vertical surface is required for spacer block installation and
33mm flat vertical surface is required for installation with extension brackets.
➤
Align the spacer blocks or extension brackets on your height marks.
➤
Align the outside edge of the end spacer blocks or extension brackets on your bracket
location marks, then mark each of the screw holes. Center any additional brackets on
the bracket location marks to mark their screw holes.
CAUTION:
The rear of the spacer blocks or extension brackets must be flush against a flat
mounting surface. Do not mount blocks/brackets on curved molding.
Mount the Spacer Blocks or Extension Brackets
■
Drill the screw holes using a 3mm drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
■
Attach the spacer blocks or extension brackets using the screws
provided.
➤
For the spacer block installation, first insert the square end
of the bushings into the slots in the spacer block. Insert the
screws through bushings.
IMPORTANT:
With spacer blocks, place the screws in the
middle of the slots to make aligning the brackets easier.
Bushings
Bushings Inserted
130mm
Headrail
End Mark
Headrail
End Mark
Screw
Height
Mark
Screw
Height
Mark
130mm
