ISSUE DATE: FEBRUARY 2018
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: NOVEMBER 2015
APPROVED BY: S. GONZALEZ
PAGE 27 OF 38
PRODUCT INFORMATION MANUAL
SECTION: 12 LUMINETTE PRIVACY SHEERS
Attach the Fabric Panel(s)
Preparations
■
If necessary, use the manual control button to traverse the fabric carriers to the fully stacked
position.
■
Stand the tube on end on a clean surface with the valance at the top. Position the tube at the
end of the headrail where the fabric stacks.
■
If the tube is too long to stand on end, carefully and safely use a utility knife to trim the tube
to an appropriate length. Do not unroll the fabric until you begin attaching the vanes to the
pinion clips.
CAUTION:
Be very careful when trimming the tube to avoid damaging the fabric in any way.
■
Remove the protective wrapping from the fabric.
Attach the Vanes to the Pinion Clips
■
Unroll the fabric to gain enough slack to attach the first vane to the
pinion clip on the motor drive assembly.
■
To attach vanes, insert the vane attachment hole into the clip until it
snaps securely in place.
➤
Pull down gently on each vane to ensure that it is seated
properly.
■
Unroll the fabric as you clip the rest of the vanes into the pinion
clips in sequence.
Be careful not to skip any pinion clips
or vanes.
Pinion
Clip
Installed
Vane
Tube
Fabric
Panel
STD
R
Vane Attachment
Swivel
Plate
Swivel
Plate
