Appendix IV
____________________________________________________________________________________________
65 | Installation, Operation & Maintenance Instructions EASYCHLORGEN
2.11 Programming the Valves in case of memory loss
Should the programming have been lost in transit the following instructions in conjunction
with the relevant setting sheet will allow you to re set them.
When the power has been connected the valve will display the software number and initialise
itself and then display
TIME
; you can then start to program the valve.
Selections are made using the
UP
and
DOWN
buttons until
the required setting is displayed: after each setting press
NEXT
to continue.
Set Time of Day:-
Press
SET CLOCK.
Adjust the hours and press
NEXT
to adjust the minutes, press
NEXT
to return to the normal
TIME
display.
Step 1: Cycle Sequence
Press
NEXT
and
DOWN
simultaneously for 3 seconds and release.
The screen will display SOFTENING flashing!
Press
NEXT
and
DOWN
simultaneously for 3 seconds.
The screen should display 1.0 Γ, adjust if necessary.
Press
NEXT
after each setting and set each setting accordingly until the display returns to TIME
Step 2: System Setup
Press
NEXT
and
DOWN
simultaneously for 3 seconds and release.
The screen will display SOFTENING flashing. Press
NEXT.
The screen should display CYCLE 1, adjust as necessary (see setting sheet that corresponds
to your system!) Press
NEXT
and set each setting accordingly until the display returns to
TIME
.
Step 3: Display Settings
Press
NEXT
and
UP
simultaneously for 3 seconds and release.
HARDNESS with 340 should appear on screen. Adjust as necessary (see quick start section.
Press
NEXT
and set each setting accordingly.
