4.7 Preparing the resin vat
-
Pour the resin from the bottle to the provided resin vat (n.6)
WARNING: always wear protective gloves and goggles when using the resin. They may cause skin,
eye and respiratory system irritation, and skin sensitization/allergic reaction by skin contact.
ATTENTION: As photosensitive pigments tend to deposit after a while, stir the resin well before
each print, in order to avoid colour spoiling.
IMPORTANT: the level of the resin MUST be at least 1 cm higher than the height of object you are
about to print
-
Uninstall the printing carriage (n.12) from the movable base (n.13), unscrewing the two
knobs (n. 14)
-
Immerse the carriage inside the vat (n.6) full of resin ( img 14.a )
-
Place the vat with the resin and the carriage on the printer internal surface (img 14.b)
-
Now install the carriage as mentioned in point 4.4.
Img.14 How to install the resin vat correctly.
IMPORTANT: Never place the resin vat when the carriage is installed by tilting the vat (img. 14.c).
Resin might pour out.
ATTENTION: In case resin is unwillingly poured on the printer internal surface, switch the printer
immediately off, absorb the resin with a paper towel and clean the surface with alcohol to remove
resin traces.
Before switching the printing on again, make sure that the liquid has been totally removed and it
has not infiltrated inside the printer bottom part where the electronic board is placed.
Always contact our service support and never open the printer bottom area, it will invalidate the
warranty.
Summary of Contents for LumiForge
Page 1: ...CRAFTER MANUAL...
