LUMIFORGE USER MANUAL 13
-
To install the projector inside the 3D printer, hold it vertically with the lamp facing down
(img. 3.a).
-
Match the plate mounted on the projector to the black plate (n. 10) inside the printer (img.
3.b)
-
Screw the two knobs provided into the two holes indicated on the plate external side (img.
3.c and img. 3.d)
-
Now connect VGA and Power Supply cable inside the printer to the corresponding socket on
the projector (img. 3.f).
ATTENTION: We suggest inserting the VGA cable between the two sustain bar (n.17) to avoid it to
interfere with projector movement (img.3.f).
Img.3 install the projector inside the 3D printer
-
Follow projector manual to turn the grey zoom ring above the projector outwards so to set
the closest zoom. Always make sure that zoom ring is in this position.
-
Install the servo-shutter provided (n.15) on the blue servo (n.16) located below the projector
(n. 8) (img.4)
-
After installation It is possible to open or close the servo-shutter manually, pressing together
the last two keys on the right on Lumiforge front panel (n.7) (img.5).
-
If, when on the closing position, the shutter does not cover all the light flux, remove it and
install it again with a rotation.
Summary of Contents for LumiForge
Page 1: ...CRAFTER MANUAL...
