3 - 51
④
Upper limit setting dial
This is used to set the upper limit of one touch lift
and auto lift function.
1. Turn the upper limit setting dial to the desired
position. According to the dial position, the
height shall be set as below.
Min. : 500mm (19.7 in.) between lower link end
and ground
Max. : maximum height of lift arm
2. When using the position control lever, this set is
not available.
⑤
One touch up/down switch
This is used to lift the implement up/down easily
at one time without operating position control
lever.
1. Press the upper side of one touch up/down
switch to lift up the implement to the upper limit.
2. Press the lower side of the switch to lower the
implement to the position set by position control
lever.
▶
If the draft control mode is set in the state that depth control cable is not attached,
this mode is not available, and continuous beep sounds.
Notice
⑥
Down speed setting dial
Turn the down speed setting dial to the left and
the down speed is getting slower and if you turn
it to the right, the down speed is getting faster.
Turn the dial to counter-clockwise fully and the
hydraulic lift shall be fixed downward and the
implement will not let down even if you put the
position control lever down.
▶
When driving on the road, turn the down speed setting dial to counter-clockwise
slightly to lock.
▶
When changing the blades of tiller or removing grass, stop the engine and turn the
down speed setting dial to counter-clockwise slightly to lock.
Caution
High
Low
▶
If the position control lever is placed over the upper limit of lift arm, the one touch
up/down function is not available.
Notice
Fast
Slow
One touch
up/down switch
