5 - 16
(8) Cleaning Cabin air filters
Before servicing the filters, switch off the blower
and close all cabin doors and windows.
Unscrew the bolts under the roof and remove
the cover and filter element as shown in the right
figure.
Clean the elements by blowing with compressed
air not exceeding 30psi (2bar). Blow the dust
from the upper surface through the element to
the underside. Hold the nozzle at least 12 in.
(300mm) from the element to prevent damage to
the filter media.
Clean all filter chambers with a damp, lint-free
cloth. Re-install the filter elements.
Re-install the filter cover and tighten the bolts.
▶
The filters are made of specially treated media with a rubber sealing strip bonded
around the sides. Take care not to damage the element during installation.
Notice
Cabin
air filters
Bolt
Filter
cover
(7) Hydraulic hoses and Leakage
Stop the engine and place all the transmission
gears in neutral and lower down the implement
to the ground.
Periodically check hydraulic system for leaks or
damaged parts - kinked, crushed, flattened, hard
blistered, heat cracked, charred, twisted, soft or
loose covered hoses and fittings.
Before removing hydraulic components, make
sure to check that hydraulic pressure is relieved
completely. The leaks of pressurized oil can
cause a fatal physical injury.
For further information, see chapter, “3-5.
Hydraulic system” in this manual.
(5) Battery check
Refer to “Batter handling and Notices”
(See page 5-36)
(6) Air cleaner (Dry type)
(See page 5-10 )