5 - 20
(5) Tension adjustment of Fan belt
If the tension of fan belt exceeds the normal
value, loosen the bolts and adjust the tension.
- Belt tension : crank shaft pulley ~ alternator
pulley
- Normal : approx. 10~12mm (0.4~0.5 in.)
(When pressed by 98N (22 lb))
When adjusting the tension,
1. Loosen two bolts of alternator and bolt of
adjusting plate slightly.
2. Insert the bar between crank case and pull the
bar to apply tension to the belt.
3. With proper tension, tighten the upper bolt of the
alternator, and tighten the other bolts.
Adjusting plate
Bolt
Alternator
pulley
Cooling water
pump pulley
Crank shaft
pulley
Element
Indicator
(7) In-line pressure filter (if fitted)
If this in-line pressure filter is clogged, the
automatic leveling control or electro-hydraulic lift
(EHL) may not be operated smoothly.
This filter is located in front of the right rear axle
housing.
If the indicator installed on the filter housing is
changed from green color to red color, replace
the element with a new one.
(6) Toe-in
Check Toe-in of the front wheel and if needed,
adjust it as below.
Normal value : B – A = 0~5 mm (0~0.2 in.)
Loosen lock nut of the tie-rod (both side).
Fix steering cylinder and turn adjuster counter-
clockwise, the toe-in (“B-A”) shall be increased.
Turn adjuster of the other side to the same
displacement.
After adjusting Toe-in, tighten the lock-nuts.
If possible, contact your authorized local dealer.
A
FRONT
B
Tie-rod
Lock nut
Adjuster
Lock nut
