3 - 31
►
Before shifting the main gear shift lever or range gear shift lever, depress the
clutch pedal fully to disengage the clutch completely. If not, it may cause damage to
the transmission gear.
►
To start the engine, you have to place the shuttle lever in neutral position and place
the PTO switch in OFF position, and then depress the clutch pedal fully.
►
Before operating the shuttle lever, you should sit correctly in the driver’s seat.
►
Before changing the direction of the tractor by using the shuttle lever, be sure to
check the safety condition of your directions, especially in reverse.
►
It is dangerous to shift the shuttle lever without slowing down in high speed driving.
Before changing direction, it is necessary to reduce the driving speed. If not, it may
cause damage to the power shuttle clutch and transmission drive line.
►
Proper transmission oil temperature is necessary to the performance of the power
shuttle. Be sure to warm-up the tractor until the blinking of the neutral indicator is
stopped and do not operate the tractor hastily, especially in cold weather.
►
Park the tractor on level ground and apply the parking brake. If you have to park
the tractor on a slope, apply the parking brake, and apply the wheel chocks to the
wheels. Engaging low speed gear is NOT useful to protect the slippage of the
tractor having the power shuttle system.
Caution
If the hydraulic pressure of the shuttle system goes lower than proper level during operation,
corresponding error code (SPN, FMI code) shall be displayed on the instrument panel with
continuous alarm. At this time, move the shuttle lever to neutral position first. DO NOT try to operate
the tractor any more, because the clutch engagement under a lower pressure can cause damage to
the clutch plate even for a few seconds. Contact your authorized local dealer immediately to get
some instructions or to check the problem. Even though the alarm sounds, the tractor can be moved
restrictively for escaping from an emergency state.
