Setup
ProtoMat M60
17
5.0 Setup
5.1 Before switching on
Caution! Be sure the voltage set at the machine corresponds with
the line voltage: If not, continue at „Fuses, commuting the device
Before switching on, all items are to be removed from the machine and
its range of movement. Alignment pins are not allowed to jut out from the
base material. Alignment pins serves to fix, and by the twirl of the base-
material as reference point of the brush mirror.
Danger! Never reach into the machine while it is running!
5.2 Turning the system on
The following switching on order is useful, but not essential:
1.
Computer
2.
LPKF
ProtoMat
M60
3.
Start the
BoardMaster
program
If for some reason it should be necessary to switch the machine off and
on again, then change to the
MACHINE/SETTINGS
window of the
BoardMaster
program and click on
OK
. Through all necessary
initialization parameters like speed ranges, dwell times positions and so
on are again transmitted to the machine.
5.3 Switch-on instructions for high-speedcycle
spindles
A tool must always be placed in the shaft of the high-speedcycle spindle
when the machine is switched on. The collet must always be closed and
the knob of the high-speedcycle spindle must be in itsist top position,
otherwise the spindle is blocked and the motor driver can be overloaded.
Caution! The Danger of spindle can be damaged if it operated
without a tool inserted!
Danger! Do not operate with the tool clamp before the spindle is
standing absolutely still!
