78
3.14 GLOW PLUGS OPERATING INSTRUCTIONS (ONLY ON SELECTED MODELS)
To switch the gas jets on press the knob and turn it anti-
clockwise; the glow plug will turn bright red and cause the gas
jet’s flame to light.
WARNING
It is reccomended not to leave any inflammable materials
on top of the kitchen’s work surface, such as cloths and
grease proof paper, which could catch fire just by pressing
the knob, even when the gas jets are switched off.
Make sure every precaution is taken; by pressing the knobs the glow plugs will
immediately turn on and reach 1300° in temperature.
The glow plugs must not be knocked to avoid damaging them.
TO AVOID BURNS AND INJURIES THE GLOW PLUGS MUST NOT BE TOUCHED WHEN THEY ARE
BRIGHT RED. CHILDREN MUST BE KEPT AT A SAFE DISTANCE.
4. CLEANING
Before cleaning turn off at the mains and leave the oven and burners to cool.
Clean the hob and oven after each use in order to prevent build-ups of stubborn dirt that are
difficult to remove and may damage the surfaces.
To clean the stainless steel, enamelled, and glass parts and the
control panel, we recommend using a sponge or damp cloth with
a non-abrasive cleaner. If spots are difficult to take off, please use
specific cleaning products.
Rinse and dry carefully after the
cleaning
. Do not use steel wool, abrasive powders and corrosive
substances that could scratch.
To keep the internal enamelled parts shiny for a long time, they
should be cleaned frequently with warm soapy water. The grid
guides and drip pan can be removed by unscrewing the
nuts/washers G for more thorough cleaning. Refit the parts by
placing the 2 P extensions of the side guides in the holes F on the
bottom of the oven;
line up the 2 front eyelets of the guides with the screws fitted to the sides,
then secure the guides with nuts/washers G. Do not wash the oven when it is still hot and do not
use abrasive substances or products.
Ensure that the enamelled surface do not come into prolonged with acid and alkaline
substances, such as: VINEGAR, COFFEE, MILK, SALT WATER, LEMON JUICE, TOMATO
JUICE, ETC.
The burners, caps, and flame diffusers should be cleaned periodically with soapy water. Before
replacing them in their housing they should be dried carefully and check that the holes in the
flame diffusers are clear.
Do not use steam cleaners to clean the appliance.
The presence of the symbol below means that the instrument is part of “new waste”
and so it has to be gathered separately ( no urban waste).
Summary of Contents for 8022389009704
Page 85: ......
