Lofra 8022389009704, Service Manual, Page: 69 / 86

69
To increase or decrease the cooking time turn the knob clockwise or anticlockwise until the
desired time is reached.
The flashing of the “STOP” icon continues for 10 seconds from the last setting, if by this time the
programming isn’t made, the function ends and the hands will return to display the time.
Push the knob to confirm the program (at least 2 minutes) so the cooking can start. To display
the selected program push the knob quickly.
At the end of the cooking the “STOP” icon will flash and the alarm will beep. After 1 minute the
alarm will be disabled, but the “STOP” icon will keep on flashing until the knob is pushed.
To stop the program before the settled time, push the knob for 3 seconds: the program will be
deleted and the timer will return to the manual cooking set up.
START COOKING DIGITAL PROGRAMMER
Programming the start cooking time allows to automatically start and stop the cooking.
To program the start cooking time, briefly push the knob until the “START” icon flashes.
To increase or decrease the start cooking time, turn the knob clockwise or anticlockwise.
The flashing of the “START” icon continues for 10 seconds after the last setting.
If by this time the programming isn’t made, the function ends and the hands will return to display
the time.
If the knob is pressed the cooking start time is set (at least 1 minute) (the “START” icon is lit on
and steady). The next step is the setting of the end cooking time (the “STOP” icon starts
flashing).
To program the end cooking time follow the procedure below.
The two icons “START” and “STOP” will remain on to indicate successful programming.
TIMER PROGRAMMING
The timer programming allows to set a simple alarm at the end of a programmed time without
starting up the cooking.
To set an alarm, press briefly the knob three times until the icon “TIMER” stars flashing.
Then turn the knob, the timer programming is identical to the end cooking time program (see the
relevant paragraph)
The timer can be used only when there is no ongoing function.
DISPLAY OF THE SELECTED PROGRAM
To display the selected program briefly press the knob, at the same time the programmer
displays the program moving the hands on the selected time. The flashing of the relevant icons
indicates the different phases.
The programmer will then return automatically to display the current time and the execution of
the selected program.
DELETION OF THE SELECTED PROGRAM
To delete the selected program, push the knob for some seconds until you hear a beep and the
relevant icons are off.
The programmer will then return automatically to the manual cooking mode.
BLACKOUT SIGNAL
The timer does not cancel the program in case of blackout.
The timer signals any lack of power supply through the flashing of the “CLOCK” icon, in order to
verify that the time is set correctly.