LOAD KING 35-127 M, Operator'S Manual

Page: 192 / 216

192
35-127 M
Service / Parts
6� Using the choker strap and hoist, pin the upper leg to the mainframe bracket� Lower the leg until
the links align with the hole in the outrigger leg boss�
7� Install the pin through the links and outrigger boss and install the snap rings�
8� Connect the outrigger hoses� Cycle cylinder several times to full stroke to remove any air in the
cylinder�
1 Holding Cartridge 6 Piston Nut
2 Rod 7 Piston
3 Barrel 8 Spacer
4 Thread Cap 9 Gland
5 Set Screw
REMOVAL & DISASSEMBLY OF AUXILIARY OUTRIGGERS
1� Either work with the rear outriggers over a pit or raise the rear of the truck so that there is at least
36” of clearance from the bottom of the outrigger shoes�
2� Extend outrigger leg 1” and shut off power� Move control handles to relieve trapped pressure�
3� Tag and disconnect cylinder hoses� Cap hoses and fittings on cylinder�
4� Support the inner leg while removing the upper pin�
5� Swing cylinder inward to rest against inner leg� Carefully lower inner leg out of housing�
6� Remove lower pin snap rings and pin� Using a hoist, pull the cylinder out of the inner leg�