LOAD KING 35-127 M, Operator'S Manual, Page: 151 / 216

151
A1 Access Holes Inner Bolt Circle B6 1-8NC Nut
A2 Outer Bolt Circle B7 1-8NC Socket Head Bolt
A3 Turret Assembly C1 Turret Base Plate
B1 Swing Stop Bolt C2 Fitting in Rotation Gear (2ea - 180 degrees
apart
B2 Turret Base Plate C3 Rotation Gear
B3 Rotation Bearting C4 Grease Tubes
B4 Hardened Flat Washer C5 Zerk “A”
(Zerk “B” located on opposite side of turret)
B5 Mainframe Top Plte C6 Street side of Pedestal
2� Regular periodic lubrication will increase the life and serviceability of the rotation bearing� Being a
heavily loaded bearing, it’s recommended that an extreme pressure grease (such as Texaco
Starplex #2) be used�
Under normal operation, the rotation bearing should be greased once a week� The grease zerks are
located at the streetside operator’s console (or driver’s side) by the inspection opening of the
mainframe� There is one grease zerk for each side of the rotation bearing, 180° apart�
To properly grease this bearing, the unit should be set up with the outriggers in an operating
position� Attach the grease gun to a zerk and apply 3 full shots from the grease gun� Repeat for the
other grease zerk� Then rotate the boom 90° and repeat the above steps� This operation should
continue through a 360° cycle of the rotation� See the previous location chart�
NOTE:
A shot is considered as one full pump stroke on a standard chassis type grease gun. It is
important to not over-grease and create a wasteful run-off situation.