LMI Gocator 2000 Family, User Manual

Page: 33 / 194

Getting Started • 33 Gocator 2000 Family
If the upgrade operation is performed when a Buddy is assigned, the firmware on both Main and Buddy will be
updated. Therefore, it is important that users perform the upgrade when the Buddy is connected to the main
sensor.
The firmware on Main and Buddy sensors must be the same for the Buddy assignment to be successful.
Therefore, the user must ensure the Buddy assignment is active before attempting to upgrade a dual-sensor
system. If the firmware is different, connect the Main and Buddy sensor one at a time and refer to the section
on Updating Firmware (page 32) for the correct upgrading procedure.
Next Steps
After completing the steps in this chapter, the next tasks in configuring a Gocator measurement system
are as follows:
Setup and Calibration
Steps to configure laser profiling are described in Setup (page 34).
Measurement Configuration
Sensors that are equipped with profile tools can be programmed to perform measurements. Refer to
Measurement (page 62) for more information.
Output Configuration
Profile data, measurements, and Pass/Fail results can be transmitted to external devices for process
control or data analysis. Refer to Output (page 94) for more information.