40
Picture 33 - Custom setting of dial - up rules
Table 19 - Dial - up rule configuration table
Parameters
Description
Dial rule
There are two types of matching: Full
Matching or Prefix Matching. In Full
matching, the entire phone number is
entered and then mapped per the Dial
Peer rules.
In prefix matching, only part of the number
is entered followed by T. The mapping with
then take place whenever these digits are
dialed. Prefix mode supports a maximum
of 30 digits.
Note: Two different special characters are used.
x -- Matches any single digit that is dialed.
[ ] -- Specifies a range of numbers to be matched. It may be a range, a list of
ranges separated by commas, or a list of digits.
Destination
Set Destination address. This is for IP
direct.
Port
Set the Signal port, and the default is 5060
for SIP.
Alias
Set the Alias. This is the text to be added,
replaced or deleted. It is an optional item.
Note: There are four types of aliases.
all: xxx – xxx will replace the phone number.
add: xxx – xxx will be dialed before any phone number.
del –The characters will be deleted from the phone number.
rep: xxx – xxx will be substituted for the specified characters.
