9
6.3
Installation instructions
6.3.1
Installation
1. Draw the installation holes on the wall according to the installation dimension drawing
provided by the equipment, use an electric drill to make the vacant place, after drilling the
hole, remove the installation dimension drawing, and use a hammer to drive the plastic
plug into the drilled hole;
2. Use a screwdriver to loosen the 4 screws on the back, separate the back shell from the
wall bracket, and lock the screws on the back of the device at the same time;
3. Align the screw holes of the wall bracket with the holes made on the wall, and fix it to
the wall with the supplied screws;
4. Pass all the wires through the silicone plug in the middle of the bottom shell. All wires
need to reserve a length of 15-20cm.
5.
Hang the device and the wall bracket tightly from top to bottom, and tighten the screws
at the bottom
Picture 6 - Installation
6.3.2
Device IP address
Method 1:
Open the iDoorPhone Network Scanner. Press the Refresh button to search the device
and find the IP address.
Method 2:
Connect the speaker, touch and hold the speed-dial button for 3 seconds (30 seconds
after power on), wait for the speaker to beep. Press the speed-dial button within 5
seconds, and the system will automatically announce the IP address by voice.
Method 3
：
