Linhai ARCHON 400, Service Manual

Page: 73 / 218

CHAPTER 3 ENGINE
BUCK 450 SERVICE MANUAL 20.0
A.C. MAGNETO ROTOR REMOVAL
1. Remove:

Nut

(rotor)

Plain washer

NOTE:

Loosen the nut (rotor)

while holding the rotor
with a sheave holder

.

Do not allow sheave the holder touch to the
projection on the rotor.
2. Remove:

Rotor


Woodruff key
NOTE:

Remove the rotor

using the flywheel puller.

Center the flywheel puller over the rotor.
Make sure after installing the holding bolts that the
clearance between the flywheel puller and the
rotor is the same everywhere. If necessary, one
holding bolt may be turned out slightly to adjust
the flywheel puller's position.
CAUTION:
Cover the crankshaft end with the box wrench for
protection.
STARTER DRIVE GEAR INSPECTION
1. Inspect:

Starter idle gear teeth

Starter drive gear teeth

Starter wheel gear teeth
Burrs /chips /roughness /wear
→
Replace.
2. Check:

Starter clutch operation
Push the dowel pins to the arrow direction.
Unsmooth operation
→
Replace.
Checking steps:

Hold the starter clutch.

When turning the starter wheel gear clockwise,
the starter clutch and the starter wheel gear
should be engaged.

If not, the starter clutch is faulty. Replace it.

When turning the starter wheel gear counter
clockwise, it should turn freely.

If not, the starter clutch is faulty. Replace it.
CHAPTER 3 ENGINE PAGE. 3- 48