Linhai ARCHON 400, Service Manual

Page: 181 / 218

CHAPTER 7 BRAKES
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 7 BRAKES PAGE. 7- 12
INSPECTION
Measure the thickness of the pad friction material.
Replace pads if worn beyond the service limit.
Service Limit 0.3/64"(1 mm)
INSTALLATION
1. Install new pads in caliper body.
2. Install caliper and torque mounting bolts.
Brake Caliper Torque: 18 ft. lbs. (25 Nm )
3. Turn adjuster screw back in finger tight using a
hex wrench.
4. Slowly pump the brake lever until pressure has
been built up. Maintain at least 1/2 "(13 mm) of
brake fluid in the reservoir to prevent air from
entering the brake system.
5. Install wheels, burnishing procedure should be performed.
7.13 REAR CALIPER REMOVAL/ INSPECTION/ INSTALLATION
CAUTION:
The caliper is a non-serviceable Component; it must
be replaced as an assembly.
NOTE: If any special service needed, contact the
CUV manufacture via the agent for the parts and
special instruction.
1. Remove the cargobox.
CAUTION:
Use care when remove the cargobox so that it does
not turn over. Severe injury may occur if cargobox
turns over.
2. Use a wrench to remove the brake line. Place a
container to catch brake fluid draining from brake
lines.
3. After the fluid has drained into the container,
Brake Line