Lincoln 2008 MKX, Owner'S Manual

Page: 114 / 329

Keyless entry key pad autolock enable/disable procedure
1. Turn the ignition to the 1 (LOCK)
position.
2. Close all the doors.
3. Enter factory–set 5–digit entry
code.
4. Press and hold the 3
•
4. While holding the 3
•
4 press the 7
•
8.
5. Release the 7
•
8.
6. Release the 3
•
4.
The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.
Autounlock feature
The autounlock feature will unlock all the doors when:
•
the ignition is in the 3 (RUN) position, all the doors are closed, and
the vehicle has been in motion at a speed greater than 12 mph (20
km/h);
•
the vehicle has then come to a stop and the ignition is turned to the 1
(LOCK) or 2 (ACC) position; and
•
the driver door is opened within 10 minutes of the ignition being
transitioned to the 1 (LOCK) or 2 (ACC) position.
Note: The doors will not autounlock if the vehicle has been
electronically locked before the driver door is opened.
Deactivating/activating autounlock feature
Your vehicle comes with the autounlock features activated; there are four
methods to enable/disable this feature:
•
Through your authorized dealer,
•
by using a power door unlock/lock sequence,
•
using a keypad procedure (if equipped), or
•
or by using the instrument cluster message center (if equipped). Refer
to
Message center
in the
Driver Controls
chapter.
Note: The autounlock feature can be activated/deactivated
independently of the autolock feature.
2008 MKX (mkx)
Owners Guide (post-2002-fmt)
USA
(fus)
Locks and Security
113