5.SoftwareControl-LightwareDeviceController
HDMI-TPS-RX110AY series – User's Manual
55
Appliedfirmwarepackage:v1.5.0b3 | LDCsoftware:v2.5.9b2
Condition Triggering
DIFFERENCE:
This feature is available
only in HDMI-TPS-RX110AY-Plus model
fromFWpackagev1.5.0b3.
This improvement works as if a condition
is detected. When a complex control
system is built, a Condition may trigger
numerous Actions. A typical example is when a system is powered on and the ’ready-to-use’ state has to be
loaded. In this case, there could be many actions which are based on the same condition. In order to reduce
the number of the commands, you can trigger one ’key’ condition, which could start the whole process.
5.7.4.
Clear One or More Event(s)
Clear an Event
Press the
Clear
button in the Event list or in the header section in the Event editor.
Clear all Events
WhenalltheEventsmustbeclearedpressthe
Load factory defaults
button above the Event list. You will be
promptedtoconfirmtheprocess.
5.7.5.
Export and Import Events
ThefeatureallowssavingalltheEvents.ThebackupfilecanbeuploadedtoanotherHDMI-TPS-RX110AY
receiver.
Export all the Events
Step 1.
Press the
Export
button above the Event list.
Step 2.
TheSaveasdialogboxwillappear.Setthedesiredfolderandfilename,thenpressthe
Save
button.
ThegeneratedfileisasimpletextfilewhichcontainsLW3protocolcommands.Thefilecanbeviewedbya
simple text editor, e.g. Notepad.
ATTENTION!
Editingthefileisrecommendedonlyforexpertusers.
Import all the Events
Step 1.
Press the
Import
button above the Event list.
Step 2.
TheOpendialogboxwillappear.Selectthedesiredfolderandfile,thenpressthe
Open
button.
5.7.6.
Event Creating - Example
The following example shows you on a real-life situation how to set up an Event.
The Concept
The HDMI-TPS-RX110AY receiver is connected to a projector by the HDMI output port. The receiver is also
connected to the projector by the RS-232 port and can send commands via the serial line.
The task is to turn on the projector when signal is detected on the HDMI output port.
RS-232 Settings
Make sure that the serial line is established between the receiver and the projector. Check that the RS-232
settingsofthereceiverissetexactlythesamewhichrequiredfortheprojector:baudrate,databits,parity,
stopbits.Thereceiverneedstobesetto:Controlprotocol:LW3;andRS-232mode:Pass-through.Seethe
relevantLDCsettingsinthe
Setting the Event
YoucancreatetheEventintheWizardinfewsimplesteps:
Step 1.
Set the condition.
Selecttherequiredparameterstosetthecondition:
▪
Category
:Video;
▪
Expression
:Signalisdetectedonaport;
▪
Port
:O1.
Click on the
Apply
buttontocompletetheprocedure.Whenitisdone,theconditionappearsontheupperside
intextualandLW3commandformataswell.
