![background image](http://html1.mh-extra.com/html/light-my-bricks/10266/10266_instructions-manual_1911510004.webp)
Incorrectly inserting the connector can can result in bent pins inside the port or possible
overheating of the expansion board when connected.
Connecting cable connectors to Strip Lights
Take extra care when inserting connectors to ports on the Strip Lights.
Connectors can be inserted only one way. With the Strip Light facing up, ensure the side of the
connector with the wires exposed is facing down. If a plug won’t fit easily into a port connector,
don’t force it.
Doing so will damage the plug and the connector.
Connecting Micro Cable connectors to Micro Expansion Board
Ports
Take extra care when inserting the micro connectors to micro ports of Micro Expansion Boards.
Connecting Micro Bit Lights to Micro Expansion Boards is similar to connecting lights and cables
to Strip Lights. With the expansion board facing up, ensure the side of the connector with the
wires exposed is
facing down
. If a plug won’t fit easily into a port connector, do not force it. Use
your fingernail to push the plastic part of the connector to the micro port.
Summary of Contents for 10266
