![background image](http://html1.mh-extra.com/html/light-my-bricks/10266/10266_instructions-manual_1911510029.webp)
Take another
Flat Battery Pack
and insert 2x new CR2032 batteries to it. Connect the battery
pack cable to the 6-Port Expansion Board, then turn the battery pack ON to test the Jet light is
on and flickering OK.
Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies
(with the light or expansion board). To correct any issues with expansion board ports, please
view the section addressing expansion board issues on our
online troubleshooting guide.
Neaten up excess cabling by folding and twisting the Orange Bit Light Cable and 5cm Connecting
Cable around each other into a neat bunch, then turn the middle section around again.
Summary of Contents for 10266
