Place the LED in the centre of the 4 studs, then reconnect the Jet piece underneath the upper
section of the Lander. Ensure the other end of the cable is facing down and in between the two
studs of the Jet section. Take the remaining
Trans Clear Plate w Rounded Bottom 2×2
and
connect it over the Bit Light as shown below. The trans clear piece will help distribute the light
underneath the shuttle.
Summary of Contents for 10266
