6.)
Turn the bottom section of the Lander around to the front, then onto it’sback side so we
can access underneath.
Take a Cool White 30cm Bit Light
, and with the cable facing down, place
the Bit Light underneath the Lander inside the hole underneath the black 2×3 plate, as per
below. Secure the Bit Light in place by connecting a provided
Trans Clear Plate w Rounded
Bottom 2×2
over the top.
Thread the other end of the Bit Light up the following hole of the technic plate, then pull the
cable all the way out from the other side.
Summary of Contents for 10266
