Turn the Battery Pack ON to test the blue jet light is working OK and flickering!
Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies
(with the light or expansion board). To correct any issues with expansion board ports, please
view the section addressing expansion board issues on our
online troubleshooting guide.
5.)
Place the Battery Pack on top of the lander, then pull the cable inside untilthere is approx.
5cm of cable left between the battery pack and left corner of the middle section. Reconnect the
dark grey plate and push in the two light grey plates to secure the battery pack cable.
Summary of Contents for 10266
