ALED
TM
POLE MOUNT INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT.
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable
parts inside.
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your
comments. Call the us at 888-RAB-1000, or email: [email protected]
ALED10, ALED13
MOUNT TO POLE
For use with standard RAB pole drilling. See drawing
below
Mount fixture to Pole:
1.
Place
Adaptor Gasket
between the fixture and drilled
Pole
as shown. Line up center hole with center hole
in the pole drilling pattern.
2.
Place 3/8-16 bolt from the
Adaptor
thru the top hole
of the
Gasket
to the
Pole
. Use nut, lockwasher and
washer and tighten inside the pole.
3.
Make the necessary wiring connections and knot the
wires for strain relief.
4.
Install the
Pole Cap
.
Pole
Adaptor Gasket
Pole Cap
ALED20, ALED26
MOUNT TO POLE
For use with standard RAB pole drilling. See drawing
below
Mount fixture to Pole:
1.
Place
Adaptor Gasket
between the fixture and drilled
Pole
as shown. Line up center hole with center hole
in the pole drilling pattern.
2.
Place 3/8-16 bolt from the
Adaptor
thru the top hole
of the
Gasket
to the
Pole
. Use nut, lockwasher and
washer and tighten inside the pole.
3.
Make the necessary wiring connections and knot the
wires for strain relief.
4.
Install the
Pole Cap
.
Pole
Adaptor Gasket
Pole Cap
Nut, Lockwasher &
Washer
Nut, Lockwasher &
Washer
