Document:
Date:
Created By:
INSTALLATION INSTRUCTIONS
C-STRIP-B-LIN Series
http://lighting.cree.com/warranty | 866.924.3645
LPN00625X0001A1
07-17-2021
TMT
NOTE:
Wire guard brackets must be installed on fixture prior to fixture
installation.
Before Fixture Installation
1.
Attach supplied wire guard brackets to ends of fixture using (2)
screws supplied with wire guard. See
Figure 1.
NOTE:
8' fixtures require use of (2) C-STRIP-A-WG4 (1 wire
guard on each fixture section).
After Fixture Installation
1.
Align the wire guard with the wire guard brackets and clip one
edge in place. Brackets will engage with second wire guard cell
from each end of the wire guard. See
Figure 2.
2. Swing the wire guard over the lens and lock it onto the other sides
of the wire guard brackets. See
Figure 3.
WIREGUARD ATTACHMENT
(Requires use of 2' (C-STRIP-A-WG2) OR
4' (C-STRIP-A-WG4) Accessory)
(8’ Fixtures requires use of (2) C-STRIP-A-WG4
Accessories)
FIGURE 1
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before
installation.
DANGER
– Risque de choc – Couper l’alimentation
avant l’installation.
2. Caution
- Risk of Fire.
Attention
- Risque D’incendie
3.
This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n’êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
4. For dimming connections use Class 1 wiring methods.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
FIGURE 2
FIGURE 3
