Use and Care Guide
LED Path Light
-LV-2002
1001486801
B
A - Light x 1 B - Stake x 1
A
A
B
C
D
Assembly and Installtion
Attaching and installing the light
Push the stake (C) assembly into the
ground.
Do not push on the light.
1
Connecting the wires
2
IMPORTANT:
Do not instanll
install the light within 10 ft. (3m) of
a pool, spa, or fountain.
Detach and place the wire connector (D) on opposite sides of the
low voltage cable (not included) from the transformer (not included)
where the fixture will be located.
Align and fit the main low voltage cable vertically to the slot of the
wire connector (D).
Press the wire connector (D) together untilit is locked around the
main low voltage cable.Pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Once the wire connector (D) is in place, wrap it with electrical tape
(not included) for additional protection.
When the lights are installed, turn on the power.
WARNING:
The connector contacts (D) have sharp edges for
piercing the main low voltage cable. To avoid injury, do not
touch the metal contacts.
CAUTION:
The wire from the low voltage power unit shall be
12-16 AWG type underground low Energy Circult Cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the light,
fitting, or next to a building structure such as a house or a
deck.
Do not bury the wiring by more than 6 in. (15.24 cm) in order
to connect to the main secodary wire.
Do not submerge fixtures in water.
·
·
·
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
1
NOTE:
Do not use a hammer.If
the ground is hard, use water to
soften or a trowel to loosen the
soil.
(not included)
D
