LI-COR LI7200RS, Instruction Manual

Page: 125 / 226

4 Select the gas analyzer from the list and click
Update Software
.
The update will take about 5 minutes.
Important: Do not close the software, let your PC go to sleep, or power off the instrument
during the update process. The software will notify you when the update is complete.
If the update fails for any reason, repeat steps 2 and 3.
If you are updating from embedded version 4.x.x or earlier, you must also run the
FPGA update. To check if this update is necessary click the
Check FPGA
button.
Note: Do not check the FPGA version until you update the system software.
If the FPGA update is needed the
Update FPGA
button will become enabled in the
application. The FPGA update takes approximately 10-12 minutes.
Important: Do not close the software or reset the instrument while the update is taking
place. The software will notify you once the FPGA programming is finished.
5 After updating the software, check all your instrument configuration settings. The instrument
should retain all settings through a software update, but in unusual circumstances, some settings
may be lost.
Troubleshooting: Getting an update error? There must be a USB drive installed
in the LI-7550 USB port before you can update. Also, if the drive is inserted for
the first time, the instrument will take a few minutes to connect with the drive.
Section 5. Maintenance
5-13 Embedded Instrument Software