L'HOTELLIER
COMPONENT MAINTENANCE MANUAL
12589-( )
PRINTED IN FRANCE
26-20-50
Page 3008
APR 01/11
Fill Plug Weld-Machining Tool
Figure 3005/GRAPHIC 26-20-50-99B-807-A01
(e)
Loosen the set screws and remove the tool. Look at the weld and make sure that
the joint is broken.
(f)
Remove the pressure switch (220) and shims (140, 150, 160,170) from the switch
fitting . Discard the shims.
Subtask 26-20-50-020-006-A01
F.
Fill Plug (container empty)
(1)
Put the container in the holding fixture with the fill plug pointed up.
(2)
Put the feed bushing on the fill fitting and tighten the set screws. Refer to figure 3005,
item 2.
(3)
Attach a low speed drill press or hand drill motor to the shank end of the cutter.
(4)
Adjust the depth of the drill press to 0,5 mm (0.020 in).
(5)
Operate the drill press from 60 to 80 rpm until the weld joint breaks. Use cutting oil during
the machining operation.
(6)
Loosen the set screws and remove the guide and cutter feed bushing. Look at the weld
and make sure it is cut.
The document reference is online, please check the correspondence between the online documentation and the printed version.
