LGMG SR1623, Operation And Maintenance Manual

Page: 82 / 86

Lifting Work Platform Operation and Maintenance Manual
75
△ !
Never clean the safety filter tube (4).
1) Screw off the hexagon bolt (5) and the safety filter tube (4).
2) Install the new safety filter tube and screw on the hexagon bolt.
3) Install the filter element (3), place the outer cover (2) and fix it with the positioning plate (1).
11.24 Check for Coolant Liquid Level
Check the coolant liquid level every 8 hours or every day.
△
! The coolant at high temperature has the risk of scald.
The cooling system is under pressure! The cover can only be opened in the cooling state.
Coolant must have a specified concentration of cooling system protectant!
Please observe the safety regulations for coolant and relevant local regulations.
Dispose of the spilled coolant as specified, without leaving it on the ground.
Never run the engine without coolant, even if it's a very short time.
1) Carefully open the cover for the cooling system.
2) The coolant liquid level shall always be between min and max! Fill up to the maximum liquid level if
necessary.
11.25 Filling or Replacement of Engine Coolant
Replace it every 2,000 hours or two years.
△
!
The coolant at high temperature has the risk of scald.
The cooling system is under pressure! The cover can only be opened in the cooling state.
Coolant must have a specified concentration of cooling system protectant!
Please observe the safety regulations for coolant and relevant local regulations.
Dispose of the spilled coolant as specified, without leaving it on the ground.
Never run the engine without coolant, even if it's a very short time.
Draining of the Cooling System
1) Carefully open the cooler cover.
2) Place the receiving container under the coolant interface.
3) Drain the coolant.
4) Reconnect and tighten the coolant interface.
5) Close the cooler cover.
Filling of the Coolant
1) Carefully open the cover for the cooling system.
2) Fill the coolant to max or the filling limit position.
3) Open the possible heater and switch to the maximum gear, to fill the heating circuit and exhaust.
4) Close the cooler cover.
5) Run the engine to the running temperature.
6) Shut down the engine.
7) Check the coolant liquid level when the engine is cooled, and fill it to max if necessary.