LGMG SR1623, Operation And Maintenance Manual

Page: 79 / 86

Lifting Work Platform Operation and Maintenance Manual
72
It is available in the first 50 hours, and the engine oil and filter shall be replaced every 250 hours or a
quarter. (If the ambient temperature continues to be below -10
℃
. (14
゜
F) or the temperature of engine
oil is below 60
℃
(84
゜
F), or the sulphur content in the diesel fuel is 0.5 - 1%, the oil change period is
reduced by a half; if the engine oil does not reach the replacement interval period within a year, the oil
shall be replaced at least once a year.)
△
! Danger of burn, be careful of high-temperature engine parts and oil, contacting with high
temperature engine oil and/or engine parts will cause severe burns.
△
!
Perform the function after engine warmup to normal operation temperature.
Replacement of engine oil-Kubota engine
1) Warm up and run the engine (engine oil temperature> 80
℃
).
2) Place the engine horizontally.
3) Shut down the engine.
4) Place the container under the engine oil drain plug.
5) Screw off the engine oil drain plug to drain the old engine oil.
6) Install the new seal ring for the engine oil drain plug and screw in and tighten it.
7) Add engine oil at the engine oil filler. Engine oil filling capacity is
9.5 L.
8) Warm up and run the engine (engine oil temperature> 80
℃
).
9) Place the engine horizontally.
10) Check the engine oil level and fill it if necessary.
Replacement of the Engine Oil Filter
The engine oil filter element must also be replaced every time the
engine oil is replaced.
△
!
Never fill the filter in advance. There is risk of
contamination.
1) If a torsion stopper is installed, remove the clamping clamp
(optional).
2) Release and unscrew the filter element with a wrench.
3) Contain the oil that was drained.
4) Clean the sealing surface of the filter holder with a clean
fiber-free wiper.
5) Apply a thin layer of engine oil to the seal ring of the new filter.
6) Screw in a new filter manually until seal fit and tighten it with
15-17 Nm.
Tighten the torque.
7) Fix the clamping clamp of a torsion stopper (optional).
11.20 Check for Fuel Leakage
1 Oil measuring rod 2 Oil filler 3
Engine oil drain plug