LGMG SR1623, Operation And Maintenance Manual

Page: 14 / 86

Lifting Work Platform Operation and Maintenance Manual
7
2) Pay attention to the position of the extension platform when moving the machine.
3) Check the operation areas to avoid obstacles overhead or other possible hazards.
4) Be careful of extrusion hazards when grasping the platform guard railing.
5) Users must comply with service regulations of personal protection equipment as required by the
employer, in workplace and stipulated in government laws and regulations.
6) Observe and use the direction arrows of driving and steering functions on the PCU and platform
labels when driving and steering.
7) Don't operate the machine on any running route of crane or high-altitude machinery unless the
crane controller has been locked and/or precautions have been taken to prevent any potential
collision.
8) Prohibit dangerous driving or play when the machine is operated.
9) It is allowed to lower the platform when there are no staff and obstacles in the area under the
platform.
10) Restrict driving speed according to ground condition, jamming degree, gradient, staff position and
any other factors that may cause collision.
11) Recommend the operator to wear qualified safety helmet when the machine is operated.
1.13 Hazard of Component Damage
1) Do not use any battery or charger greater than 12 V to start up the engine.
2) Do not use the machine as the ground wire during welding.
3) Do not use the machine in the place where there may be magnetic field.
1.14 Hazard of Explosion and Fire
1) Do not use the machine in hazardous place or the place where there may be inflammable or
explosive gas or particles.
2) Do not start up the engine if the liquefied petroleum gas (LPG), gasoline, diesel or other explosive
substances are smelled or perceived.
3) Do not refuel the machine when the engine is operated.
4) It is allowed to refuel the machine or charge the battery only in the open and well-ventilated places
far away from sparks, flames, burning cigarettes, etc.
1.15 Hazard of Machine Damage
1) Do not use the damaged or faulted machine.
2) Be sure to perform a thorough check before operation of machine and test all functions before each
shift. The damaged or faulted machine shall be marked immediately, and the operation shall be
stopped.
3) Ensure that all maintenance operations have been performed as specified in this manual.
4) Ensure that all labeling positions are proper and easy to be identified.
5) Ensure that this manual is stored in document box on the platform.