LED Indicators
5-4
InterReach Unison Installation, Operation, and Reference Manual
CONFIDENTIAL
D-620003-0-20 Rev J
5.1.2
RJ-45 Connector
The RAU has one RJ-45 connector that connects it to an Expansion Hub using
Cat-5/5E/6 ScTP cable. Use shielded RJ-45 connectors on the Cat-5/5E/6 cable.
NOTE:
For system performance, use only Cat-5/5E/6 ScTP cable with
shielded RJ-45 connectors.
5.2
LED Indicators
Upon power up, the RAU goes through a two-second test to check the LED lamps.
During this time, the LEDs blink green/green red/red. This lets you visually verify
that the LED lamps and the firmware are functioning properly.
NOTE:
Refer to Section 9 for troubleshooting using the LEDs.
Status LEDs
The RAU status LEDs can be in one of the states shown in Table 5-2. These LEDs
can be:
off
steady green
steady red
There is no off state when the unit’s power is on.
Table 5-2
Remote Access Unit LED States
LED State
Indicates
Off
Off
• The RAU is not receiving DC power.
Green
Green
• The RAU is powered and is not indicating a fault condition. Communication with the
Expansion Hub is normal; but the system test may need to be performed or a warning con-
dition could exist (use AdminManager to determine).
Green
Red
• The RAU is indicating a fault or lockout condition, but communication with the Expansion
Hub is normal.
Red
Red
• The RAU is reporting a fault or lockout condition, and it is not able to communicate with
the Expansion Hub.
LINK
ALARM
LINK
ALARM
LINK
ALARM
LINK
ALARM
