18
Operation and settings
Audio
Audio In
> Enable: Click the check box if you want to send the audio
from the microphone input connector.
Note:
The Clients connected to the IP device remain unaffected
with additional changes made in the setting.
> Input: Select the type of audio input. (Line in, Microphone)
> Audio type: Select the type of audio encoding.
(G711 PCMA, G711 PCMU, G726 24K, G726 32K)
Audio Out
> Enable: Click the check box to output the audio from the
speaker.
Note:
Depending on the camera and Network condition, it may
delay for a few seconds.
•
Save: Click this button to confirm the settings.
PTZ config (Optional)
PTZ protocol list
> PTZ protocol: Displays the selected PTZ protocol.
PTZ configuration
> Camera ID: Enter the PTZ device ID. Make the same ID as the
PTZ Device.
> Pan speed: Enter the panning speed of the PTZ device in the
edit box.
> Tilt speed: Enter the tilting speed of the PTZ device in the
edit box.
> Zoom speed: Enter the zoom speed of the PTZ device to
view the object close or at a distance.
> Focus speed: Enter the focus speed of the PTZ device to
focus an object clearly near or far.
Port
> Baud rate: Select the desired speed of communication
between the IP device and the PTZ Device. Confirm selected
parameter to the baud rate of the IP device.
> Data bit: Set the number of the data bits for RS-485
communication.
> Parity: Select the desired parameter. The parity bit, added to
the data, to perform parity check.
> Stop bit: Enter the desired parameter. The stop bit, added to
the last of data, in asynchronous communication.
•
Save: Click this button to confirm the settings.
Summary of Contents for LNB5110
Page 40: ......
