2. INTRODUCTION
9
ENGLISH
2-1. General Information
This manual describes the installation of water cooled screw chiller with X30 controller applied.
2-2. System structure
Figure 1 shows the general parts location and components of the water cooled screw chiller.
The location of control panel, type of waterbox, directions of inlet and outlet of the chilled water and cooling water
and some pipes may vary by model or customer order. Please check the approved drawings for the details.
* Prepare and check the approved drawing that fits the site.
1
2
10
4
5
6
7
8
3
9
12
11
1
3
15
14
16
1
8
17
19
Part Name
1. Screw compressor
2. Relief valve for condenser
3. Relief valve for evaporator
4. Air vent for cooling water
5. Air vent for chilled water
6. Drain for cooling water
7. Drain for chilled water
8. Lifting hole(4 holes) for condenser
9. Lifting hole(4 holes) for evaporator
10. Sight glass for evaporator
11. Control panel
12. Starter panel
13. Flow switch (Chilled water)
14. Flow switch (Cooling water)
15. Temperature sensor (Chilled water outlet)
16. Temperature sensor (Cooling water outlet)
17. Temperature sensor (Chilled water inlet)
18. Temperature sensor (Cooling water inlet)
19. Sight glass for condenser
Front view
Rear view
Figure 1 General structure of screw chiller
2. INTRODUCTION
Summary of Contents for LCWW
Page 119: ......