Lexmark XC2326, User Manual

Page: 236 / 254

Mode Description Power consumption (Watts)
Scan The product is scanning hard
‑
copy documents. 22 (MC3224adwe, MC3224i); 24 (CX331,
MC3324); 21 (CX431, MC3426, XC2326)
Ready The product is waiting for a print job. 17 (CX331, MC3224, MC3326); 17.5 (CX431,
MC3426, XC2326)
Sleep Mode The product is in a high
‑
level energy
‑
saving mode. 1.1 (CX331, MC3224, MC3326); 1.3 (CX431,
MC3426, XC2326)
Hibernate The product is in a low
‑
level energy
‑
saving mode. N/A
Off The product is plugged into an electrical outlet, but
the power switch is turned off. 0.1
The power consumption levels listed in the previous table represent time-averaged measurements.
Instantaneous power draws may be substantially higher than the average.
Values are subject to change. See www.lexmark.com for current values.
Sleep Mode
This product is designed with an energy-saving mode called Sleep Mode . The Sleep Mode saves energy by
lowering power consumption during extended periods of inactivity. The Sleep Mode is automatically engaged
after this product is not used for a specified period of time, called the
Sleep Mode Timeout .
Factory default Sleep Mode Timeout for this product (in minutes): 15
By using the configuration menus, the Sleep Mode Timeout can be modified between 1 minute and 120 minutes.
If the print speed is less than or equal to 30 pages per minute, then you can set the timeout only up to 60
minutes. Setting the Sleep Mode Timeout to a low value reduces energy consumption, but may increase the
response time of the product. Setting the Sleep Mode Timeout to a high value maintains a fast response, but
uses more energy.
Hibernate Mode
This product is designed with an ultra
‑
low power operating mode called Hibernate mode . When operating in
Hibernate Mode, all other systems and devices are powered down safely.
The Hibernate mode can be entered in any of the following methods:
•
Using the Hibernate Timeout
•
Using the Schedule Power modes
Factory default Hibernate Timeout for this product in all countries or regions 3 days
The amount of time the printer waits after a job is printed before it enters Hibernate mode can be modified
between one hour and one month.
Notes on EPEAT-registered imaging equipment products:
•
Standby power level occurs in Hibernate or Off mode.
•
The product shall automatically power down to a standby power level of ≤ 1 W. The auto standby function
(Hibernate or Off) shall be enabled at product shipment.
Notices 236