Lexmark E360D series, Service Manual

Page: 40 / 166

2-14
Lexmark™ E360d, E360dn
4513-420, -430
922.07 Media reached fuser nip and fuser is under temperature
922.08 Fuser warm-up failure (motor start condition)
922.09 Fuser warm-up failure (compression set)
922.20 Belt fuser failed to reach the preheat temperature for the motor to start during warm-up.
922.21 Belt fuser was under temperature when the media reached the fuser nip.
923.00 Fuser is over temperature.
923.01 Fuser is over temperature. This applies to the fuser and belt fusers.
924.00 Open thermistor check.
924.01 Open thermistor check failure. This applies to the fuser and belt fusers.
924.02 Open thermistor check failure. The ADC failed to converge. Possible noisy thermistor signal. This applies to the
fuser and belt fusers.
925.00 Wrong fuser lamp installed.
925.01 Lamp detection performed and found error.
925.02 Too hot to do lamp detection and NVRAM bit indicates previous wrong lamp detected.
Fan service errors
927.00 Service fan error
927.03 Main fan took too long to ramp up
927.04 Main fan is under speed or stalled during speed adjustment state
927.05 Main fan overspeed during speed adjustment state.
927.06 Main fan capture data is invalid and speed control is at maximum in fan control idle state
927.07 Main fan capture data is invalid and speed control is at maximum in fan control adjustment state.
Printhead service errors
931.00 No first hsync
931.01 No first hsync
932.00 Lost hsyncs
932.01 Lost hsyncs
933.01 Printhead boost signal failure
934.00 Mirror motor lost lock.
934.01 Mirror motor lost lock.
935.10 Printhead sweep error, swept through Hz range without finding the resonant frequency
935.11 Printhead sweep error, autosweep hw state
935.12 Printhead sweep error, coarse sweep state
935.13 Printhead sweep error, init fine sweep state
Service error codes (9 xx ) (Continued)
Error Description