Lexmark E360D series, Service Manual

Page: 37 / 166

Diagnostics information
2-11
4513-420, -430
201.27 Page at fuser nip before fuser reached acceptable operating temperature. Page arrived at fuser earlier than
expected, so it was probably staged
202.00 Paper jam around exit sensor.
202.01 Exit sensor never broke on the trailing edge of the sheet at the exit sensor.
202.02 Exit sensor never broke from sheet ahead of page heading toward the exit sensor.
202.06 Exit sensor bounced
202.13 Exit sensor covered, media not expected (media not in machine during warm-up)
202.25 Exit sensor never broke from the sheet ahead of the page heading toward the exit sensor when feeding out the
media detected during warm-up.
202.26 Trailing edge never cleared exit sensor when feeding out media that was detected during warm-up.
202.32 Long media or shingled multi feed stopped before sending to duplex.
231.00 Duplex jam while reversing into the device
231.01 Duplex sensor never made by leading edge reversing into the duplex.
231.02 Bouncy duplex sensor never made.
232.00 Duplex jam while staging in the device
232.01 Duplex sensor never broke by the sheet ahead after reversing into the duplex.
232.02 Page in duplex ahead of current reversing page never staged.
233.00 Duplex jam while picking from the device
233.01 Page in duplex never picked.
233.02 Feed error picking from the duplex.
233.03 Paper never reached the input sensor, but was detected at the manual feed sensor.
234.01 Duplex sensor covered during warm-up.
235.01 Invalid duplex media
241.00 Paper jam near tray 1.
241.10 Second pick attempt failed from Tray 1
241.12 Second pick from manual feeder, tray 1, or feeder failed when the media was in the source while other sheets
were committed to the paper path.
241.16 Failed to feed from tray 1. Pages in the paper path have been flushed to the output bin.
241.17 MISIDENTIFIED SMALL GAP JAM. Engine detected small gap at the manual feeder sensor, attempted to
open the gap by stopping the feed rolls, trailing edge was seen at the input sensor, manual feeder sensor is no
longer covered.
241.18 MISIDENTIFIED NO GAP JAM. Engine detected no gap at the manual feeder sensor, attempted to open the
gap by stopping the feed rolls, trailing edge was seen at the input sensor, manual feeder sensor is no longer
covered.
241.19 Second pick attempt failed from Tray 1, no pages printed since calling a 241.10 or a prior 241.19.
242.00 Paper jam near tray 2.
Paper jam error codes (200-series) (Continued)
Error Description