Lexmark CX310dn, Service Manual

Page: 195 / 394

To change this setting:
1
Select Format Fax Storage from the Configuration Menu.
Note: If an advanced password has been established, then you must enter this password to change the setting.
If no advanced password exists, then you can establish one by using the keyboard that appears on the LCD.
2
Select Submit to save the change.
3
Select Back to cancel and return to the Configuration Menu.
Formatting Fax Flash DO NOT POWER OFF
appears on the display while the format operation is active.
Flatbed edge erase
This menu item sets the size, in millimeters, of the no print area around a flatbed scan job. Copy jobs will use the setting
or two millimeters, whichever is larger.
To adjust the flatbed edge erase setting, perform the following steps:
1
Select FB Edge Erase from the Configuration Menu.
[setting's current value]
displays.
2
Select minus to decrease the setting’s value or plus to increase the setting’s value.
3
Select Submit to save the change.
4
Select Back to cancel and return to the Configuration Menu.
Scanner manual registration
This item is used to manually register the flatbed and ADF on the MFP’s scanner unit. Registration should be performed
whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually register a Duplex ADF, perform the following steps:
1
In the Configuration Menu, scroll to the Scanner Manual Registration menu item.
2
Select Scanner Manual Registration .
3
Select Print Quick Test Page .
4
To view and adjust the duplex ADF front side registration, place the quick test page face up into the ADF.
5
Select Copy Quick Test .
6
After the quick test page copies, select ADF Front .
7
Use the plus to increase or the minus to decrease the settings value for horizontal adjust and top margin.
Note: Each button press moves the margin values one pixel in the respective direction.
8
Select Submit to accept the value.
9
changes by placing the print quick test page face up and selecting Copy Quick Test .
10
Repeat steps 6, 7, and 8 as needed.
11
To view and adjust the duplex ADF backside registration, place the quick test page face down up into the ADF, and
select
Copy Quick Test .
12
After the quick test page copies, select ADF Back .
7527
Service menus
195