Lexmark 7016-630, Service Manual

Page: 106 / 455

Insufficient memory service check
Action Yes No
Step 1
Check the memory card for proper installation.
Is it properly installed?
Go to step 2. Reseat the memory
card.
Step 2
a
Print the Menu settings page:
Settings > Reports > Menu Settings Page
b
POR into the Configuration menu and reset the printer’s settings to
factory default:
Configuration Menu > Factory Defaults > Restore Base
c
Remove the memory card.
d
Restart the printer.
Does the error remain?
Replace the controller
board. See
“Controller
board removal” on
page 239
.
Replace the memory
card.
Toner cartridge smart chip service check/Imaging unit smart chip service check
Action Yes No
Check if the firmware level is compatible with the hardware level.
Are they compatible?
Contact the next level
of support. Flash the correct
firmware level.
Printer hardware errors
•
“1xx error messages” on page 108
•
“111.xx LSU service check” on page 111
• “Fuser service check” on page 111
• “LVPS service check” on page 112
• “Toner density sensor service check” on page 112
•
“CTLS service check” on page 113
•
“Main drive gearbox service check” on page 113
•
“ACM service check” on page 114
• “Cartridge gearbox service check” on page 114
• “Tray 1 pick/lift motor gearbox service check” on page 115
• “171.xx Cooling fan service check” on page 115
•
“9xx error messages” on page 116
•
“System software error service check” on page 119
•
“NVRAM mismatch failure service check” on page 123
• “Base printer symptoms” on page 125
7016
Diagnostic information
106