Lexicon 300, Owner'S Manual

Page: 99 / 155

5-7
The Presets
P204 DM: Rev/Comp
EA:707:”U”Chamber EB:901:EZ Comp2:1
This preset utilizes a chamber preset on the left input and a compressor preset on the right input. Typically, EZ Comp2:1
should be used at a patch point on the console. If used on an effect send, make sure the fader sends are pre-fade, or a phase
error will occur between the fader signal and the return to the console.
MchA EA:707 “U” Chamber This preset is shaped liked an upside down “U” with the speaker on top of the wall, and a
microphone on either side of the wall.
MchB EB:901 EZ Comp 2:1 An “easy” preset to add to an overall stereo mix or mono or stereo submix. You might need
to adjust Threshold to make it work for the particular signal you feed it. Release is set to gently (2:1) fall away after 363ms.
P205 DM: Dly/Dly
EA:609: Chorus EB:612: EKOz
Think of this preset as the chorus preset for mono sources. Left input feeds Machine A; right feeds Machine B. Both effects
have their flange glides attached to the Setup LFO. The LFO is set to 1.38Hz with a sine waveform.
MchA EA:609 Chorus The Chorus preset makes use of a small variation in the glide delay to modulate the sound. The
glide moves between 9.7ms and 11.8ms. Advancing the LFO to values near 1.50Hz to 2.0 Hz, yields a nice chorusing effect.
There are no other delay lines, but the output lines are channel-swapped such that the left input passes to the right output
and vice-versa. In a Dual Mono Setup, this is ,of course, inaudible.
MchB EB:612 EKOz EKOz makes use of the flange gliding delay (via the Setup LFO) and several
longer recurring echoes.
P206 DM: *Dly/Pch
EA:601: *Dual Delays EB:804: Sky Down
This preset incorporates a Setup Soft knob patch to the effect in Machine A (*Dual Delays). Paging up one page will activate
the Soft knob as a multi-parameter controller. In this Setup, going to this location in Setup Select mode will change the stereo
delay parameter in preset 601 which is loaded into Machine A (left input). Machine B (right input) loads a pitch shift program.
MchA EA:601 *Dual Delays Baseline effect with the Soft knob patched to the last two delay lines in the signal path.
Advancing the Soft knob will cause the two post-delays to move in sync out to almost 3000ms.
MchB EB:804 Sky Down This preset tunnels downward due to the liberal amount of delay feedback. If the effect is too
heavy, lower the Feedback value. This preset has no Mod Edit patches.
P207 DM: Dly/Comp
EA:602 Space Delays EB:902 DrumComp3:1
This preset presents a delay preset to the left effect input/output, and a Drum compressor preset to the right effect input/
output.
MchA EA:602 Space Delays This preset incorporates a bit of left-right diffused delay, along with some small delay offset
between left and right delay outputs. If the effect is too strong, try lowering feedback levels for delays 3 and 4.
MchB EB:902 DrumComp 3:1 This is a bit more aggressive, with 7dB of boost below the selected threshold. A quick
release of 58ms snaps up the volume. As with all compressor presets, Threshold is the critical parameter.