Lexicon 300, Owner'S Manual

Page: 96 / 155

Lexicon
300 V 3.0 Owner's Manual
5-4
Single Setup
Presets cont'd.
# Name Algorithm Description
P126 * Rich Plate Rich Plate The old standard comes back to the future. Advancing the Soft knob
controls the reverb time negatively.
P127 Glossy Plate Rich Plate This preset shines a little differently. Some close in pre-echoes gives
a strong impact to the original source.
P128 Warm Plate Rich Plate Not your average bright plate — rather a slightly dull version which will
work very well on horn tracks, adding point and definition.
P129 Perc Plate Rich Plate For drums and the like. Not bad on piano either.
P130 Contem-Plate Rich Plate Bright and splashy-sounding. Should work well to brighten a track
without getting too washy-sounding.
P131 *EKO Plate Rich Plate Combines a sweet combination of recirculating pre-echoes and bright
sounding reverb. The Soft knob is negatively patched to RTIM and
Delays 1 and 2.
P132 Bright Plate Rich Plate Slightly smaller version of Contem-Plate. Great of vocals. Some
strong pre-echoes to help the direct sound stand out.
P133 * Round Plate Rich Plate Soft, but articulate. The Soft knob is patched to feedback paths
surrounding pre-echoes 1 and 2, which feedback into the
reverberator.
# Name Algorithm Description
P134 StereoAdjust Stereo Adjust Sets you up to fix audio sources. Null preset with pages for EQ,
delays, phase and channel swaps, and DC offset removal.
P135 Phase Invert Stereo Adjust The right channel is phase reversed to the left. If you put a mono
signal into this program and pan the output returns left and right,
you’ll definitely twist your head off.
*NOTE This phase-reversed mono signal will also decode to the
surround channel if run through a surround decoder.
P136 2 Frame Delay Stereo Adjust 66.3 ms of delay running at 44.1kHz and 65.9 ms at 48kHz.
P137 3 Frame Delay Stereo Adjust 100 ms of delay at both operating frequencies.
P138 4 Frame Delay Stereo Adjust 133 ms of delay at both operating frequencies.
P139 MS Decode Stereo Adjust Take a 2-channel Mid (left input) Side (right input) recording and this
program will properly decode to stereo output.
P140 *MultiEchoes Stereo Adjust This preset combines echoes under the control of the Soft knob. As
you advance the Soft knob, the delays will get longer.
P141 LFO Panner Stereo Adjust This preset attaches the LFO to the Stereo Adjust balance control.
Once again, the LFO Rate determines the speed of the pan. This
preset should be used from a pre-fade send source.
P142 Telephone Stereo Adjust No bottom end....AT ALL.